A self‑priming pump shares most parts with a standard API 610 centrifugal pump, plus a gas‑liquid separation chamber and recirculation ports.
Standard volute section – converts velocity to pressure.
Enlarged upper chamber – gas‑liquid separator. Volume calculated to allow air to escape.
Partition wall – separates separator from impeller eye.
Recirculation port(s) – return separated liquid to impeller area (external or internal mixing).
Priming port / vent – for initial filling of stored liquid.
For discharge sizes DN80 and larger, the casing is double volute – two opposed passages balance radial hydraulic forces, reducing shaft deflection and extending bearing life.
| Impeller type | Efficiency | Solids handling | Best application |
|---|---|---|---|
| Closed (enclosed) | High (70‑80%) | Poor (clean liquids) | Hydrocarbons, water, chemicals |
| Open / semi‑open | Medium (55‑70%) | Good (fibers, small solids) | Wastewater, pulp, slurries |
Impellers are dynamically balanced to ISO 1940 Grade G6.3. Materials include 304 SS, 316L SS, duplex, and high‑chrome alloy.
The bearing housing is modular and designed for back pull‑out – the entire rotating assembly can be removed without disturbing piping. Bearings are heavy‑duty, with L10 life ≥25,000 hours (API 610 requirement). Lubrication: oil bath (standard) or forced oil mist.
The seal chamber is fully API 682 compliant, accepting single, tandem, or dual pressurised cartridge seals. Standard flush plan: Plan 11 (self‑flush). Optional: Plan 21 (cooled flush), Plan 23 (recirculation cooler), Plan 53B (dual pressurised for hazardous fluids). Seal faces: carbon/ceramic (clean water) or SiC/SiC (abrasive/corrosive).
Cooling jacket – for high‑temperature service (>150°C) – circulates coolant to protect bearings and seals.
Heating jacket (steam or electric) – for high‑viscosity fluids or cold climates – maintains fluidity and prevents freezing.
Heavy‑duty grouted steel baseplate with drip lip and drain. Flexible spacer coupling allows seal and bearing replacement without moving the driver.
For any inquiries, please contact: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.