A conventional centrifugal pump must be flooded before start‑up – the casing and suction line must be completely filled with liquid. If the pump is installed above the liquid source (e.g., tank, pit, river), the suction line drains back when the pump stops. Restarting requires manual priming (filling the casing) or a foot valve to hold liquid in the suction pipe. Foot valves often leak, and manual priming is hazardous when handling corrosive or flammable fluids.
An API 610 self‑priming pump incorporates a specially designed casing that retains a volume of liquid after shutdown. When the pump starts, this stored liquid is recirculated to evacuate air from the suction line. The pump automatically transitions to normal centrifugal operation once the suction line is filled.
1. Mixing stage – The impeller rotates, mixing the stored liquid with air drawn from the suction line. A turbulent gas‑liquid mixture is created.
2. Separation stage – The mixture enters the gas‑liquid separation chamber (enlarged upper casing). Because gas and liquid have different densities, air rises and is expelled while liquid falls back to the impeller eye.
3. Suction stage – As air is progressively removed, a partial vacuum forms. Atmospheric pressure pushes liquid up from the source. Once the casing is full, the pump operates as a standard centrifugal pump.
| Type | Recirculation port location | Priming speed | Complexity | Typical use |
|---|---|---|---|---|
| Internal mixing | Returns liquid to impeller eye (inside) | Faster | Higher | Deep suction, lift >7 m |
| External mixing | Returns liquid to volute (outside) | Slightly slower | Simpler | General industrial, ≤7 m lift |
Maximum self‑priming lift: 9 m (clean water at sea level)
Priming time (6 m lift): ≤180 seconds
Stored liquid volume: Optimised within casing
Path A – Integrated priming casing : OH1/OH2 pump with built‑in gas‑liquid separator. Compact, fully API‑compliant.
Path B – External vacuum unit : Standard API 610 pump + vacuum priming system. Used for very long suction lines or lifts >9 m.
For any inquiries, please contact: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.