The choice of wetted materials depends on fluid corrosiveness, temperature, abrasiveness, and presence of H₂S or chlorides. Our self‑priming pumps comply with API 610 Table H material classes.
| Component | Standard | Premium | Extreme |
|---|---|---|---|
| Casing | Cast iron (C‑6) | 316L SS (S‑8) | Duplex (D‑1/D‑2), Hastelloy |
| Impeller | Cast iron / 304 SS | 316L SS | Duplex, super duplex, Ni‑hard |
| Shaft | 4140 steel | 316 SS, 17‑4 PH | Duplex, Inconel |
| Wear rings | 4140 hard | 316L + Stellite | Tungsten carbide |
| Mechanical seal faces | Carbon/ceramic | SiC/SiC | Tungsten carbide/SiC |
| Gaskets / O‑rings | PTFE / NBR | Viton (FKM) | Aflas, Kalrez |
| Fluid type | Recommended material | API 610 class | Remarks |
|---|---|---|---|
| Clean water, light oil | Cast iron (C‑6) | C‑6 | Economical, adequate |
| Sea water, brackish water | Duplex (D‑1/D‑2) | D‑1/D‑2 | PREN >35 |
| Sour water, rich amine | 316L SS | S‑8 | NACE MR0175 required if H₂S >0.05 bar |
| Caustic (NaOH) | 316L SS or nickel alloy | S‑8 / special | Avoid stress corrosion cracking |
| Hydrochloric acid | Hastelloy C‑276 | Special | Not attackable |
| High‑temperature hydrocarbons (>250°C) | Carbon steel (C‑6) with hard trim | C‑6 | Thermal expansion managed by centreline mount |
For H₂S‑containing service (sour oil & gas), all wetted parts can be supplied with NACE MR0175 / ISO 15156 certification. This includes hardness control, material verification, and third‑party inspection.
For fluids with sand, catalyst fines, or other solids:
Impellers in high‑chrome iron (Cr27) – hardness 58‑62 HRC
Replaceable hard metal wear plates
Tungsten carbide coated shaft sleeves
For any inquiries, please contact: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.