Eaton Airflex WCB Replacement Guide | How to Verify Fit

2026-11-09 20:53

Key Facts

AttributeValue
PurposeReplacement verification guide
Applies ToEATON AIRFLEX WCB / WCB2 series
Key ChecksFlange pattern, port thread, actuation type, disc wear

Step 1: Identify Your Existing Unit

Before ordering, confirm the exact model code on the nameplate. Common codes include 124WCB, 236WCB, 336WCB, and 418WCB. If the nameplate is unreadable, take a photo and send it to HYRIG engineers for identification.

Step 2: Measure the Mounting Flange

Measure the center-to-center hole spacing on the existing adapter flange. Do not rely on the model code alone, as revisions can change flange patterns. Record the number of bolts and the diameter of the bolt holes.

Step 3: Confirm the Water Port Thread

The standard reference is 1/4 SAE ORB, but confirm against your existing coolant hoses. If your hoses use a different fitting, note the thread type and size so HYRIG can match the replacement element.

Step 4: Identify the Actuation Type

Confirm whether the existing unit uses an air tube or piston type. The two are not interchangeable without checking the pressure plate configuration. If the nameplate does not specify, send a photo of the pressure plate area.

Step 5: Measure Friction Disc Wear

Measure the thickness of the existing friction disc. If it is at or below the wear limit, the replacement element must include a new friction disc, not just a bare element. For multi-disc models (336WCB, 418WCB), measure all discs in the pack.

Cross-Reference & Replacement

Wichita 424WCB and Airflex WCB units use different flange and port configurations. Do not assume cross-brand drop-in compatibility. If you are replacing a Wichita unit, confirm interface measurements with HYRIG engineers.

Internal links:

Selection Support

Still not sure which replacement element fits your drawworks? Send HYRIG the existing unit's nameplate photo, flange measurements, water port thread size, and disc thickness. Engineers will confirm the compatible element and quote with lead time.

Frequently Asked Questions

Q: How do I know if a replacement WCB element will fit my drawworks?
Verify the flange bolt pattern, water port thread, actuation type, and disc dimensions against the existing unit before ordering.

Q: Is this an original Eaton Airflex product?
No. HYRIG supplies independent, compatible replacement products and is not affiliated with Eaton Corporation.

Q: Can I replace a Wichita 424WCB with an Airflex WCB?
No. Wichita and Airflex WCB units use different flange and port configurations. Confirm interface measurements with HYRIG engineers before ordering.

Q: What is the lead time for a replacement element?
Standard lead time is quoted per order based on configuration and quantity; for urgent downtime, confirm with HYRIG engineers at inquiry.

Contact

For WCB replacement verification and selection support, contact HYRIG: info@hyrig.com

What to include for fastest quote:

  • Existing unit nameplate photo
  • Flange bolt pattern measurements
  • Water port thread type/size
  • Friction disc thickness measurement
  • Required quantity
  • Destination port

Related Pages

Name:
Message:
Verification code:
Submit
Comment