Pressure: 1.5 × design pressure (up to 330 bar / 4,800 psi)
Hold: 30 minutes minimum
Acceptance: No visible leakage, no pressure drop
Grade: API 610 Grade 2 (Grade 1 optional)
Fluid: Water at rated speed + optional cryogenic test with LN₂ or LNG for critical services.
Points: Shut‑off, 25%, 50%, 75%, 90%, 100%, 110% of BEP flow
Measured: Head, flow, power, efficiency, NPSHr
Method: Constant flow, reduce suction pressure until 3% head drop
Report: NPSHr curve at rated speed
Duration: 4 hours minimum at rated speed
Monitor: Vibration velocity (max 3 mm/s rms), bearing temperature rise (max 40°C)
| Component | NDE method | Acceptance criteria |
|---|---|---|
| Outer barrel (forging/welds) | Ultrasonic (UT) + Radiography (RT) | API 610 / ASME Section VIII |
| Shaft (forging) | Ultrasonic (UT) | No flaws >1.5 mm equivalent |
| Cast impellers / diffusers | Dye Penetrant (PT) or Radiography (RT) | No surface cracks |
Temperature: Design temperature (e.g., -196°C for LNG)
Specimens: Minimum 3 per heat lot for each thickness
Acceptance: Average impact energy ≥27 J for 9% nickel steel, ≥20 J for stainless steel
EN 10204 Type 3.1 – Full chemical and mechanical test reports
Positive Material Identification (PMI) – For alloy verification
Certified performance curve – Including NPSH curve
Hydrostatic test certificate – With witness signature
NDE reports – UT and PT results
Charpy impact test certificates
Witnessed inspection by DNV, Lloyds, Bureau Veritas, TÜV, or SGS available at every stage.
For any inquiries, please contact: info@hyrig.com
total 0 Sheet,Only 5 images can be uploaded, each less than 5m.